Forums Music Sound Engineering Arduino serial power test (LSD3)

This topic contains 0 replies, has 1 voice, and was last updated by Avatar General Lighting June 29, 2014 at 2:44 am.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #1057412
    Avatar
    General Lighting
    Moderator

    I am going to use this 6 in 6 out SPCO relay iinterfac to receive the faderstarts and send them to LSD2 (With some enhancements such as a red light condition auto switches the headphone feeds to progrsmme output but then goes back to blue once the fader is down).. there is space on my TX monitor which can handle an ANSI terminal stream so I will use that to show the status of the controlsystem;..
    first I test the serial connections

    http://www.youtube.com/watch?v=lTwvUbC9iEc

    see if you can notice what the characters are ( space 0 1 2 3 4 5 6 7 8 9 0 @ space)

    and then ANSI driver on the Arduino

    https://www.youtube.com/watch?v=gCDqUj74JQc&index=2&list=UUDEMLBfoQJiE1CvQ 1pKqxKw

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Skip to toolbar